Thank you very much for choosing a Noctua
cooler. This manual will guide you through the
installation process step by step.
Noctua AM2(+) Mounting-Kit
Installation Manual
Step 2:
NH-U12P-AM2(+)
|
Installation Manual
Required mounting parts (from the AM2(+)-bag):
Attaching the backplate
Place the backplate on the back side of the mainboard,
aligning the backplate’s screw sockets with the mainboard’s
screwholes.
Put the 4 white, thin washers under the mounting bars and the
4 red, thick washers onto the mounting bars. Now screw the
mounting bars to the backplate using the small screws with
higher thread-pitch (from the AM2(+) bag).
Step 3:
Attaching the fastening brackets to the heatsink
Choose the fastening brackets according to the desired orienta-
tion of the cooler:
When using the 90° fastening brackets, first stick the spring
screws and springs into the fastening brackets. Then screw them
to the base of the heatsink tightly using 4 short screws.
Step 4:
Applying thermal paste
If there are residual traces of thermal paste or thermal pads on
your CPU, please clean them off first.
2x springscrews
with external thread
Caution: Make sure
that the bulgings of
the mounting bars
are pointing towards
the socket.
4x short screws with
higher thread pitch
Removing the mainboard and retention
module
Step 1:
In case you want to use the NH-U12P on an assembled system,
you first have to remove the mainboard from the case as the
cooler has to be screwed together with the backplate on the
back side of the mainboard.
If your mainboard uses a retention module for CPU cooler
installation, you have to remove it first. Should you experience
any difficulties, please consult your mainboard’s manual. If
your previous CPU cooler is attached using a different mounting
mechanism, please remove it according to its manual.
1x AM2(+) backplate 2x short mounting bars
Prior to installing the cooler, please consult the compat-
ibility list on our website and verify that the cooler is fully
compatible with your motherboard.
Should you encounter any difficulties, please check the
FAQs on our website and don’t hesitate to contact our
be held responsible for any damage or losses caused by
compatibility issues.
Multilingual versions of this manual are available on our
website: www.noctua.at
Required mounting parts (from the common parts bag):
2x 90° fastening brackets 2x standard fastening brackets
4x white, thin washers 4x red, thick washers
2x pressure springs4x short screws for
fastening brackets
Press a small drop (4-5mm diameter) of NT-H1 onto the cen-
tre of the heat-spreader.
Put the heatsink onto the CPU and turn it back and forth a few
times in order to spread the paste.
When using the standard fastening brackets, tightly screw them
to the base of the heatsink using 4 short screws.
Caution: Take off the plastic cover at the bottom side of the
heatsink first!
Caution: Applying too much thermal paste will lower the heat
conductivity and cooling performance!
Rev. 1.1
(4 pages)
(4 pages)
(2 pages)
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels